>

Hyundai Equus: Water pump Troubleshooting - Cooling System - Engine Mechanical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Water pump Troubleshooting

Troubleshooting
Water Pump
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If coolant still leaks, replace a water pump.
•
If leakage stops, reuse the water pump (Do not replace the pump with a new one).
•
From gaskets or bolts
•
Check the tightening of the water pump mounting bolts.
•
Retighten the mounting bolts.
•
Check damage of gaskets or inflow of dust.
•
Replace the gasket and clean dust off.
•
From outer surface of water pump
•
Check the material or any cracks of the water pump.
•
Poor material. If any crack found, replace the water pump.
Noise
•
From bearings
•
From mechanical seals
•
Impeller interference
Inspection with a stethoscope
•
After starting the engine, check noise with a stethoscope.
•
If there is no noise, reuse the water pump (do not replace it).
•
If there is any noise from the water pump, remove the drive belt and recheck.
Inspection after removing a drive belt
•
After removing a water pump and a drive belt, check noise again.
•
If there is noise, reuse the water pump. Check other drive line parts.
•
If there is no noise, replace the water pump with a new one.
Inspection after removing a water pump
•
After removing a water pump and a drive belt, check noise again.
•
If there is any interference between them, replace the water pump with a new one.
Overheating
•
Damaged impeller
•
Loosened impeller
Loosened impeller
•
Corrosion of the impeller wing
•
Check engine coolant.
•
Poor coolant quality / Maintenance check
•
Impeller seperation from the shaft
•
Replace the water pump.

    Water pump Repair procedures
    Removal and Installation Water Pump 1. Disconnect the negative terminal (A) from the battery. Tightening torque : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) 2. Remove the air du ...

    Thermostat Components and Components Location
    Components 1. Engine coolant temperature control assembly2. Engine coolant temperature control assembly gasket3. Water outlet fitting assembly4. Water outlet fitting assembly gasket5. Water outle ...

    See also:

    8LR Brake Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Checking the power steering fluid level
    With the vehicle on level ground, check the fluid level in the power steering reservoir periodically. The fluid should be between MAX and MIN marks on the side of the gauge at the normal tempe ...

    Battery Repair procedures
    Removal 1. Disconnect the battery sensor connector (A), battery nagative terminal (B) and positive terminal (C). 2. Disconnect the vent hose connector (A) from the battery air vent hole. 3. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com