>
Hyundai Equus: License plate lamp replacement

1.Open the trunk.
2.Disconnect the negative battery cable.

3.Using a screwdriver, remove the trunk lid latch cover(1).
4.Using a screwdriver, remove the trunk lid switch(2), and disconnect the connector.

5.Detach the clip and fastener(3), then remove the trunk lid cover(4).

6.Remove the clips and screws.

7.Remove the trunk lid trim.
CAUTION
Be careful not to damage to the fasteners between the trunk lid trim and trunk lid.

8.Remove the nuts and disconnect the connectors.

9. Remove the bolts and remove the trunk key hold.

10. Remove the trunk lid panel.
CAUTION
Be careful not to damage to the fasteners between the trunk lid panel and trunk lid.

11. Remove the bolts and remove the license plate lamp.
12. Install a new light.
13. Installation is the reverse of removal.
High mounted stop light
Interior light bulb replacementElectronic Active Headrest Components and Components Location
Component location
1. Active headrest connector2. Elevator system connector3. Impact sensor4. Electronic active headrest
...
Operating Door Locks From Inside the Vehicle
With the Door Lock Button :
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the door lock button will be visible.
To lock a door, push the ...
Coolant Repair procedures
Engine Coolant Refilling And Bleeding
Never remove the radiator cap when the engine is hot. Serious
scalding could be caused by hot fluid under high pressure escaping from
...