Hyundai Equus: Operating conditions
The indicator on the switch will illuminate when the BSD (Blind spot detection) system switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 9.3 mph (15 km/h), the system will activate. If you press the switch again, the switch indicator and system will be turned off.
If the ignition switch is turned OFF and ON the system returns to the previous state.
When the system is not used, turn the system off by turning off the switch.
When the system is turned on, the warning light will illuminate for 3 seconds on the outside rearview mirror.
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above 9.3 mph (15 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of the ...
See also:
General Information
General
The supplemental restraint system (SRS) is designed to
supplement the seat belt to help reduce the risk or severity of injury
to the driver and passenger by activating and deploying the ...
Seat Belt Buckle Switch (BS) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
...
Front Door Module Repair procedures
Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Hand ...
Categories
Hyundai Equus Manuals
