>

Hyundai Equus: Heater Control Unit Repair procedures - Controller - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Heater Control Unit Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim")
3.
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.

4.
Disconnect the under lamp connector (A).

5.
Remove the stopper (B) from the glove box (A).

6.
Disconnect the air damper (A) from the glove box (B).

7.
Remove the glove box housing (A) after loosening the mounting screws and nuts.

8.
Disconnect the glove box lamp connector (A).

9.
Remove the passenger's side shower duct (A).

10.
Unscrew the mounting srcrews and then remove the control unit (A).

11.
Install in the reverse order of removal.
    Heater Control Unit Components and Components Location
    Control Panel Component Connector Pin Function Pin No.Connector AConnector B1GroundIgnition 22-FET (Gate)3Mode Control Actuator (Vent)FET (Drain Feedback)4Mode Control Actuator (Defrost)Sen ...

    See also:

    Fuel Pressure Sensor (FPS) Schematic Diagrams
    Circuit Diagram ...

    Cylinder Head Repair procedures
    Removal     • Use fender covers to avoid damaging painted surfaces. • To avoid damaging the cylinder head, wait until the engine coolant temperature drops below nor ...

    Front Door Module Repair procedures
    Replacement 1. Remove the front door window glass. (Refer to Front Door - "Front Door Window Glass") 2. Remove the front door outside handle. (Refer to Front Door - "Front Door Outside Hand ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com