Hyundai Equus: Blower Unit Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Unit Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Unit Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit") |
| 3. |
Separate the blower unit (A) from the heater unit (B) after loosening the screws.
|
| 4. |
Install in the reverse order of removal. |
Blower Unit Components and Components Location
Component Location
Components
1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...
Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...
See also:
Purge Control Solenoid Valve (PCSV) Specifications
Specification
ItemSpecificationCoil Resistance (x)14.0 ~ 18.0 [20°C(68°F)]
...
Electronic Active Headrest Components and Components Location
Component location
1. Active headrest connector2. Elevator system connector3. Impact sensor4. Electronic active headrest
...
Description and Operation
Description
The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
- ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com