Hyundai Equus: Blower

Auto Defogging Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the auto defogging connector. 3. Verify that the auto defogging actuator operates to the open position when connecting 12V to ...

Blower Unit Components and Components Location

Component Location Components 1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...

See also:

Hood Lift Repair procedures
Replacement     • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver (A ...

Master Cylinder Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the cover. 3. Disconnect the ECM connector (A) and TCM connector (B). And then take the protect ...

Compass Mirror Repair procedures
Adjustment Calibration procedure If the display read "C", calibrate the compass. 1. Driving the vehicle in a circle at less than 8km/h 3 times or until the compass heading appears. 2. Drivin ...