>
Hyundai Equus Manuals

Hyundai Equus: Mode Control Actuator Repair procedures - Heater - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Mode Control Actuator Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the mode control actuator operates to the vent mode when connected in reverse.

1. -
2. -
3. Defrost mode
4. Vent mode
5. Sensor ground
6. Feedback signal
7. Sensor (+ 5V)

4.
Connect the mode control actuator connector.
5.
Turn the ignition switch ON.
6.
Check the voltage between terminal 6 and 5.
Specification
Door position
Voltage (V)
Error detecting
Vent
0.3±0.15
 Low voltage : 0.1V or less
Defrost
4.7±0.15
 High voltage : 4.9V or more

It will feedback the current position of the actuator to controls.
7.
If the measured voltage is not within specification, substitute with a known-good mode control actuator and check for proper operation.
8.
Replace the mode control actuator if it is proved that there is a problem with it.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's side crash pad side cover.

3.
After loosening the mounting screws, remove the crash pad lower panel (A).

4.
Disconnect the crash pad lower panel switch connector (A) and knee air bag connector (B).

5.
Remove the driver's side shower duct (A) after loosening the screw.

6.
Loosen the mounting screws and remove the AVM unit (A).

7.
Disconnect the connector (A) and then remove the mode control actuator (B) after loosening the mounting screws.

8.
Install in the reverse order of removal.
    Mode Control Actuator Description and Operation
    Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. ...

    Console Temperature Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defr ...

    See also:

    Ignition Coil Description and Operation
    Description An ignition coil is an induction coil in an engine's ignition system which transforms the battery's low voltage to the high voltage needed to create an electric spark in the spark p ...

    Certification label
    The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross ...

    Driving your vehicle
    WARNING - ENGINE EXHAUST CAN BE DANGEROUS! Engine exhaust fumes can be extremely dangerous. If, at any time, you smell exhaust fumes inside the vehicle, open the windows immediately. Do not inh ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com