>
Hyundai Equus Manuals

Hyundai Equus: Heater Core Repair procedures - Heater - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Heater Core Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Heater Core Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater core cover (A) after loosening the mounting screws.

4.
Pull out the heater core (A) from the heater unit.

   
Be careful that the inlet and outlet pipe are not bent during heater core removal/installation.
5.
Install in the reverse order of removal.
A.
If you're installing a new heater core, add refrigerant oil (PAG OIL).
B.
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
C.
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
D.
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
E.
Apply sealant to the grommets.
F.
Make sure that there is no air leakage.
G.
Charge the system and test its performance.
H.
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
I.
Refill the cooling system with engine coolant.
    Heater Unit Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. 3. When the engine is cool, drain the engine coolant fro ...

    Evaporator Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater unit lower case (A) after loos ...

    See also:

    Components and Components Location
    Component Location 1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. IPM (Instrument Panel Module) ...

    Panic Button
    Press the Panic button (4) for more than one second. The horn sounds and hazard warning lights flash for about 30 seconds. To cancel the panic mode, press any button on the Smart Key. ...

    Hazard Lamp Switch Repair procedures
    Inspection 1. Check "IPM" input/output specification of hazard lamp switch using the GDS. If the specification is abnormal, replace the hazard switch module. 2. Select option "Input/output ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com