>
Hyundai Equus Manuals

Hyundai Equus: Cluster Ion Generator Repair procedures - Air Conditioning System - Heating, Ventilation and Air Conditioning - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Cluster Ion Generator Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Cluster Ion Generator Repair procedures

Inspection
1.
Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch.
Display
Fail description
00
Normal
51
Cluster ion generator fault

* For diagnostic procedure, refer to DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim")
3.
Remove the crash pad under cover (A) by pressing the locking pin.

4.
Disconnect the under lamp connector (A).

5.
Remove the stopper (B) from the glove box (A).

6.
Disconnect the air damper (A) from the glove box (B).

7.
Remove the glove box housing (A) after loosening the mounting screws and nuts.

8.
Disconnect the glove box lamp connector (A).

9.
Disconnect the evaporator temperature sensor connector, and then remove the cluster ion generator (A).

10.
Install in the reverse order of removal.
    Cluster Ion Generator Description and Operation
    Description The cluster ion generator makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When the ignition swi ...

    Cool and Warm Box Components and Components Location
    Component Location 1. Cool & Warm Box Bracket2. Wire Harness3. Front Duct4. Cool & Warm Box Assembly5. Wire Harness6. Cool & Warm Box Partition7. Circuit Board Cover8. Circuit Board9. ...

    See also:

    Fuel Tank Repair procedures
    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Turn the ignition switch OFF and disconnect the negative ...

    Engine overheat
    If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1.Pull off the road ...

    Power Steering Motor Components and Components Location
    Components 1. Oil reservoir2. Gear pump3. Motor4. ECU ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com