>

Hyundai Equus: Steering Wheel Remote Controller (SWRC) Description and Operation - Body Network System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Steering Wheel Remote Controller (SWRC) Description and Operation

Description
1.
Steering Wheel Remote Controller (SWRC)

(1)
Main features
Item
Description
Installation location
Located on the driver side handle (CAN Module is embedded in the audio switch on the upper right)
Component configuration
1.
ECU 
2.
CAN Communication IC: Body Electrical System
3.
Steering Wheel Remote Control Switch (Audio & Hands-Free/Bluetooth & Voice Recognition & LDWS&CLUSTER&SCC)
Main Features
1.
Audio control switch signal is transmitted via CAN
(VOL UP/DOWN, SEEK UP/DOWN, MUTE, MODE)
2.
Hands Free and Bluetooth control switch signals are transmitted via CAN
(Voice Recognition, CALL (SEND), HANGUP (END))
3.
Cluster display control switch signal is transmitted via CAN
(Menu OK (DISP), UP, DOWN) & Haptic Switch
4.
Cruise control switch signal is transmitted via CAN (including Smart Cruise)
(+RES, -SET, CANCEL, ON/OFF, Distance between vehicles)
5.
LDWS control switch signal is transmitted via CAN
6.
B-CAN communication IC embedded (B_CAN Communication Module)

(2)
SWRC signal flow

(3)
For detail information, refer to the Steering Wheel Remote Controller (SWRC).
(Refer to AVN system - "Steering Wheel Remote Controller (SWRC)")
    Multi Function Switch(MFSW) Description and Operation
    Description 1. Multi Function Switch (MFSW) (1) Main features ItemDescriptionInstallation location Multi Function Switch (right)Component configuration 1. ECU 2. CAN Communication IC: B ...

    Parking Guide System (PGS)
    ...

    See also:

    Valve Body Components and Components Location
    Components Location 1. Input speed sensor2. Middle speed sensor3. Output speed sensor4. E Module5. Line presure control solenoid valve6. Damper clutch control solenoid valve7. ON/OFF solenoid val ...

    Body Control Module (BCM) Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel after loosening the mounting screws. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect t ...

    Transmission Control Module (TCM) Repair procedures
    Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check poin ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com