Hyundai Equus: High beam operation
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Lighting / High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams.
The high beam indicator will light when the headlamp high beams are switched on.
To prevent the battery from being discharged, do not leave the lights on for a prolonged time while the engine is not running.
WARNING
Do not use high beam when there are other vehicles. Using high beam could obstruct the other driver's vision.
To flash the headlights, pull the lever towards you. It will return to the normal (low beam) position when released. The headlight switch does not need to be on to use this flashing feature.
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Aut ...
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). Green arrow indicators on the instrument
panel indicate which turn ...
See also:
Filler-Neck Assembly Repair procedures
Removal
1.
Disconnect the fuel filler hose (A) and the leveling hose (B).
2.
Disconnect the vapor hose quick-connector (A) after removing the trunk luggage trim.
3.
Remove the rear-LH whee ...
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
Heated Oxygen Sensor (HO2S) Troubleshooting
Signal Waveform
Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle
Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle
Fig.3) Typical ...
Categories
Hyundai Equus Manuals
