>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the height sensor linkage (A) installed on the front axle and rear axle.
(Number of height sensor : Air suspension - 4EA, Non-air suspension - 2EA)
[Front]
[Rear] |
3. |
Remove the height sensor assembly after disconnecting the connector.
[Front]
[Rear] |
4. |
Remove the height sensor unit (A) after removing screws(2EA).
[Front]
[Rear] |
Installation |
1. |
Install the height sensor unit. |
2. |
Install the height sensor assembly after connecting the connector. |
3. |
Install the height sensor linkage on the front axle and rear axle. |
4. |
Connect the negative (-) battery terminal. |
Trip Computer Mode
This mode displays driving information like the tripmeter, fuel economy, and
so on.
❈ For more details, refer to “Trip Computer” in this chapter. ...
Repair procedures
Adjustment
TCM Learning
When shift shock is occurred or parts related with the transmission are replaced, TCM learning should be performed.
In the following case, TCM learning is required.
...
Components and Components Location
Components
1. BSD (Blind Spot Detection) switch module (ON/OFF switch & state LED)2. Speaker (Built in the cluster)3. Head Up Display (HUD)4. BSD warning lamp (Built in the outside mirror)5. ...