AFLS Unit(ECU)
AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle).
Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp.
It transmits driving information by using LIN protocol, it is
operated in Fail-safe reaction mode In case system failure occurred.
Swivelling Actuator
Swivelling actuator inside H/Lamp is provided driving
information of left / right side by using LIN protocol from AFLS
Unit(ECU).
It dirve to control position by using step motor.
In case of system failure, it provides function to back to initial position(center) .
Levelling Actuator
Levelling actuator inside H/Lamp is provided driving information of upper / lower by using LIN protocol from AFLS Unit(ECU)
It dirve to control position by using step motor.
In case of system failure, it provides function to lower to -2.8% or -1.5% position.
Inspection
Initialization and diagnosis sequence by using diagnostic equipment
Below content summarize the procedure for A/S using Diagnostic equipment
Download Parameter
1.
Select "AFLS" menu ...
Removal
AFLS Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing (A). (Refer to the Body group - "Crash pad")
3.
Disconnect the glove box housing connect ...
See also:
Description and Operation
Description
The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
- ...
Description and Operation
Description
1.
System operation
HUD is a system that displays various information ahead of
the wind shield glass for safety and convenience so that the driver can
view the vehicle information ...
Headlight escort function
If you turn the Engine Start/Stop Button to the ACC or OFF position with the
headlights ON, the headlights (and/or tail lights) remain on for about 5 minutes.
However, if the driver’s door is op ...