>
Description |
1. |
Input part : It is provided that information of speed sensor, height sensor and so on related to condition of vehicle. |
2. |
Control part (AFLS Unit) : It controls Output part by analyzing/judging Input signal. |
3. |
Output part : It drive Low beam of H/Lamp to upper/lower and
left/right side optimum beam pattern according to output control signal
of AFLS Unit. |
Content | Description | |||||||||
1 | Dynamic Bending (Swivelling) |
| ||||||||
2 | Automatic Leveling (Leveling) |
| ||||||||
3 | Fail-safe |
|
Content | Description | |||||||||
1 | Enhanced stability |
| ||||||||
2 | Enhanced convenience |
|
Operation |
1. |
General
System initialization, In case of input Engine signal (AFLS ECU, Levelling /Swivelling motor)
Adaptation of AFLS OFF switch
AFLS operate normally ,only under turning low beam switch on.
Providing Tell-tale function of AFLS(display 'AFLS OFF' on dashboard)
In case of system failure, display blinking 'AFLS OFF' on dashboard. |
2. |
Main function
Swivelling function
Levelling function
Processing signal of Height sensor(Air suspension) |
1. |
General
communicate AFLS Unit through LIN protocol
Robust control to Disturbance
Doesn't work out of rated voltage range. |
2. |
Main function & Rating
Drive Low beam to left / right side
Fail-safe function : In case of detecting malfunction or system failure , drive to secure position
gear ratio (150 : 1)
Operating voltage : 10V ~ 16V
Operating current : 100mA |
1. |
Main spec
communicate AFLS Unit through LIN protocol
Robust control to Disturbance
Doesn't work out of rated voltage range. |
2. |
Main function & Rating
Drive Low beam to upper / lower
Fail-safe function : In case of detecting malfunction or system failure , drive to secure position
Drive type : Micro step mode (1/16)
Operating voltage : 10V ~ 16V
Operating current : 600mA |
1. |
General
Height Sensor connecting body & suspension measures inclination information from load condition.
Vehicle having the Air-suspension system transmits inclination signal to AFLS ECU by using CAN protocol.
Vehicle having the Steel-suspension system transmits inclination signal to AFLS ECU by using Hard-wire. |
2. |
Rating
Rated Voltage : 5V ± 5% |
Operating Door Locks From Outside the Vehicle
To lock the doors, press the button on the outside door handle while carrying
the Smart Key with you or press the Door Lock button on the Smart Key.
Put your hand in the driver’s outside door han ...
Hazard Lamp Switch Repair procedures
Inspection
1.
Check "IPM" input/output specification of hazard lamp switch
using the GDS. If the specification is abnormal, replace the hazard
switch module.
2.
Select option "Input/output ...
Knee Airbag (KAB) Module Components and Components Location
Components
...