Hyundai Equus: Rear combination lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / Rear combination lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / Rear combination lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Loose the nuts holding the rear combination lamp (outside) then disconnect the connector (A).
|
| 3. |
Remove the rear combination lamp assembly (A).
|
| 4. |
Replace the rear combination lamp assembly if the LED get out of order.
|
Head Lamps Repair procedures
Inspection
Head Lamp Relay Inspection
1.
Pull out the head lamp relay (Low) (A) from the engine compartment relay box.
A : Head lamp(Low) relay
2.
Check for continuity between terminals. The ...
Room Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver.
3.
Remove the room lamp (A) after removin ...
See also:
Gauges
Speedometer
The speedometer indicates the speed of the vehicle and is calibrated in miles
per hour (mph) and/or kilometers per hour (km/h).
✽ NOTICE
On the "User Settings Mode" ...
Output Speed Sensor Schematic Diagrams
Circuit Diagram
...
Steering gear box, linkage & boots/lower arm ball joint
With the vehicle stopped and engine off, check for excessive free-play in the
steering wheel.
Check the linkage for bends or damage. Check the dust boots and ball joints for
deterioration, cracks ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com