>
Hyundai Equus Manuals

Hyundai Equus: Front Wiper Motor Repair procedures - Windshield Wiper/Washer - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Wiper Motor Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Wiper Motor Repair procedures

Removal
1.
Remove the windshield wiper arm (A) and blade after removing a nut.
Tightening torque :
27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft)

2.
If necessary of removing the wiper blade, push both sides of lock buttons (A) and then remove the wiper blade.

3.
Remove the weather strip then remove the cowl top cover (A) after removing clips.

4.
Remove the windshield wiper motor and linkage assembly after removing 4 bolts. Disconnect the wiper motor connector (A) and windshield deicer connector (B) from the wiper motor & linkage assembly.
Tightening torque :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5.0 ~ 7.9 lb-ft)

Installation
1.
Install the wiper arm and blade to the specified position.

   
For your convenience, move the windshield wiper blades to the service position as follows;
1.
Turn the ignition OFF
2.
Move the wiper switch to the single wiping position and hold the switch until the wiper arm is in the fully up position.
3.
Raise the wiper arm.
4.
Replace the blade assembly.
5.
Return the wiper arm on the windshield.
6.
Turn the ignition to the ON position.
7.
Move the wiper switch to any position and then to the OFF position.
   
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
   
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.
    Front Wiper Motor Components and Components Location
    Components 1. Nut cap2. Nut3. Wiper arm4. Wiper blade5. Cowl top cover braket6. Cowl top cover7. Washer bolt8. Wiper motor & linkage assembly ...

    Front Washer Motor Repair procedures
    Removal     1) When servicing the washer pump, be careful not to damage the washer pump seal. 2) Do not operate the washer pump before filling the washer reservoir. Failure ...

    See also:

    Damper Clutch Control Solenoid Valve Schematic Diagrams
    Circuit Diagram ...

    Troubleshooting
    Troubleshooting Category Error symptoms inspection item Detailed inspection item Related partsLighting • HUD not working • Lighting brightness not automatically controlled (no diff ...

    Front Door Outside Handle Repair procedures
    Replacement 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the front door outside handle cover (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com