>
Hyundai Equus Manuals

Hyundai Equus: Windshield Wiper-Washer Switch Repair procedures - Windshield Wiper/Washer - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Windshield Wiper-Washer Switch Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch Repair procedures

Removal
1.
Remove the steering column upper and lower shrouds after loosening screws.

2.
Disconnect the multifunction switch connector (A).

3.
Remove the wiper & washer switch (A) by pushing the lock pin.
   
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.

4.
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

5.
Loosen the screws (2EA) from the multifunction switch assembly (A).

Installation
1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring.
   
-
Set the center position by setting the marks between the clock spring and the cover into line.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Install the steering column upper and lower shrouds.
4.
Install the steering wheel.
   
Make sure the multifunction switch connectors are plugged in properly.
Inspection
1.
Check IPM input/output specification of windshield wiper/washer switch using the GDS. If the specification is abnormal, replace the windshield wiper/washer switch module.
2.
Select option "Input/output monitoring".

    Components and Components Location
    Component Location 1. Windshield wiper arm & blade2. Wiper & washer switch3. Windshield washer hose4. Windshield wiper motor & linkage5. Washer motor6. Washer reservoir ...

    Front Wiper Motor Components and Components Location
    Components 1. Nut cap2. Nut3. Wiper arm4. Wiper blade5. Cowl top cover braket6. Cowl top cover7. Washer bolt8. Wiper motor & linkage assembly ...

    See also:

    Driver’s seat
    (1) Seat sliding forward or backward Seat height and cushion tilting adjustment (2) Seat cushion length adjustment (3) Seatback angle adjustment (4) Headrest height adjustment (5) Driver position ...

    Limousine Under Body
    Under body Projected dimensions Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...

    Trunk Lid Key Holder Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com