>
Hyundai Equus: Body Control Module (BCM) Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Disconnect the connector, bolt and nuts from smart key unit, BCM and tilt & telescopic unit.
|
| 4. |
Remove the smart key (A) and BCM unit (B) after loosening bolt and nuts.
|
| Installation |
| 1. |
Install the smart key unit and BCM unit and then connect the connectors. |
| 2. |
Install the crash pad lower panel. |
| 3. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
The body control module can diagnose by using the GDS more quickly.
The BCM communicates with the GDS and then reads the input/output value and drives the actuator. |
| 2. |
To diagnose the BCM function, select the menu of model and body control module.
|
| 3. |
Select "Input/output monitoring", if you will check current
data of body network system. It provides input/output status of each
module.
|
| 4. |
If you will check each module data operation forcefully, select "Actuation test".
|
| 5. |
If you want to change user option, select “user option”.
|
Description and OperationMode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the
mode control actuator based on the signal of the A/C control unit. ...
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram
...
Starting the engine
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, slippers, ski boots, etc.) may interfere with your ability to use the
brake and accelerator pedal. ...