>

Hyundai Equus: External AMP Components and Components Location - Premium AVN System - Body Electrical System - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: External AMP Components and Components Location

Components

Connector Pin Information
No.
Connector A
Connector B
Connector C
1
B (+)
Right surround (+)
right rear door (+)
2
B (+)
Left surround (+)
left rear door (+)
3
B (+)
Rear right midrange/tweeter (+)
Right front midrange/tweeter (+)
4
-
Rear left midrange/tweeter (+)
Left front midrange/tweeter (+)
5
CAN (+)
-
Right front door (+)
6
CAN (-)
-
Left front door (+)
7
ACC
Center speaker (+)
right rear door (-)
8
-
-
left rear door (-)
9
-
Right surround (-)
Right front midrange/tweeter (-)
10
-
Left surround (-)
Left front midrange/tweeter (-)
11
NAVI (+)
Rear right midrange/tweeter (-)
Right front door (-)
12
Sub woofer 2 (+)
Rear left midrange/tweeter (-)
Left front door (-)
13
Sub woofer 1 (+)
-
x
14
GND
-
15
GND
Center speaker (-)
16
GND
-
17
-
x
18
SPDIF (+)
19
SPDIF (-)
20
-
21
-
22
-
23
-
24
NAVI (-)
25
Sub woofer 2 (-)
26
Sub woofer 1 (-)

    Rear LCD monitor Repair procedures
    Removal     Take care not to scratch the crash pad and related parts. 1. Disconnect the negative (-) battery terminal. 2. Remove the LCD monitor bezel (A) from the front s ...

    External AMP Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Open the trunk, remove the right trunk trim. (Refer to Body - "Trunk Trim") 3. Remove the external amplifier after disconneting ...

    See also:

    Components and Components Location
    Components 1. Glass panel2. Decoration cover3. Drip link4. Guide assembly5. Drip rail6. Sunshade7. Defector8. Defector link 9. Seal tape10. Motor11. Frame12. Set plate ...

    Hood Seal Weatherstrip Repair procedures
    Replacement 1. Detach the clips, then remove the hood seal weatherstrip (A).     • Be careful not to scratch the hood seal weatherstrip. 2. Installation is the rev ...

    8LR Brake Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com