>
Replacement |
1. |
Pull it up and remove the rear seat cushion assembly (A). |
2. |
Install in the reverse order of removal.
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
After loosening the mounting bolts and then pull it up and remove the rear seat back assembly (A).
|
3. |
Disconnect the rear seat back extension connector (A) and airbag connector (B). |
4. |
Install in the reverse order of removal.
|
Heated Oxygen Sensor (HO2S) Specifications
Specification
A/F Ratio (x)Output Voltage(V)RICH0.6 ~ 1.0LEAN0 ~ 0.4
ItemSpecificationHeater Resistance (x)Approx. 9.0 [21°C(69.8°F)]
...
Owner maintenance schedule
When you stop for fuel:
Check the engine oil level.
Check coolant level in coolant reservoir.
Check the windshield washer fluid level.
Look for low or under-inflated tires.
WARNING
Be ca ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...