>
Hyundai Equus Manuals

Hyundai Equus: Rear Bumper Beam Assembly Repair procedures - Rear Bumper - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Bumper Beam Assembly Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
Disconnect the bumper antenna connector (A).

3.
Disconnect the rear bumper joint connector mounting clip (A).

4.
Remove the mounting clips (B), then remove the rear bumper beam assembly (A) and then loosen the clips.

5.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Rear Bumper Beam Assembly Components and Components Location
    Component Location 1. Rear bumper beam assembly ...

    Front Seat
    ...

    See also:

    SRS Control Module (SRSCM) Components and Components Location
    Components ...

    Evaporator Core Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") 3. Remove the heater unit lower case (A) after loos ...

    High mounted stop light
    1. Remove the rear seat 5 Seater 1.Disconnect the negative battery cable. 2.Remove the rear seat cushion. 3.Loosen the mounting bolts, then remove the rear seat back. 4.Disconnect the conne ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com