>
Hyundai Equus Manuals

Hyundai Equus: Sunvisor Repair procedures - Roof Trim - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Sunvisor Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Roof Trim / Sunvisor Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).

2.
Disconnect the sunvisor lamp connector (A).

3.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
    Sunvisor Components and Components Location
    Component Location 1. Sunvisor2. Retainer ...

    Assist Handle Components and Components Location
    Component Location 1. Assist handle ...

    See also:

    Camshaft Position Sensor (CMPS) Troubleshooting
    Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...

    Components and Components Location
    Components Location 1. Smart Junction Box (SJB)2 . Body Control Module (BCM)3 . Smart Key Unit (SMK)4 . Driver Door Module (DDM)5 . Assis Door Module (ADM)6 . Cluster (CLU)7 . Around View Monitor ...

    VSM OFF Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the airbag module. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") 3. Remove the TORX screws to rem ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com