>
Hyundai Equus Manuals

Hyundai Equus: Crash Pad Under Cover Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Crash Pad Under Cover Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Under Cover Repair procedures

Replacement
[LH]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
2.
After loosening the mounting screw, then remove the crash pad under cover [LH] (A).

3.
Disconnect the under lamp and diagnosis connector (A).

4.
After loosening the mounting screws, then remove the crash pad under cover (A).

5.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
[RH]
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
2.
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down in the direction of the arrow.

3.
Disconnect the under lamp connector (A).

4.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Crash Pad Side Cover Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Crach Pad Center Panel Components and Components Location
    Component Location 1. Crash pad center panel ...

    See also:

    G Sensor Schematic Diagrams
    Circuit diagram 1. G-sensor connector 2. G-sensor terminal function NoFunction1Signal2Ground3Power(5V) 3. Circuit diagram ...

    Front Door Module Repair procedures
    Replacement 1. Remove the front door window glass. (Refer to Front Door - "Front Door Window Glass") 2. Remove the front door outside handle. (Refer to Front Door - "Front Door Outside Hand ...

    Specifications
    Specification Air Conditioner ItemSpecificationCompressorType7VSX18Oil type & CapacityPAG 120± 10cc (4.1±0.3oz.)Pulley typeAround rubber damperDisplacement180cc/revCondenserHeat rejection18, ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com