>
Replacement |
1. |
Pull down rear door window glass by pressing the power window glass switch. |
2. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
3. |
After loosening the mounting screws, then remove the rear door belt outside weatherstrip. |
4. |
Remove the rear door belt inside weatherstrip. |
5. |
Remove the door frame inner cover. |
6. |
Remove the rear channel door frame garnish. |
7. |
Loosen the rear delta lower channel (C) mounting bolts. |
8. |
Remove the glass mounting plug hole (B). |
9. |
Carefully adjust the rear door window glass (A) until you can
see the bolt, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
10. |
Install in the reverse order of removal.
|
Front Seat Assembly Repair procedures
Replacement
1.
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.
2.
Remove the front seat track mounting cover.
3.
After loosening the mount ...
Battery Sensor Repair procedures
Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolts (B).
Installation
...
Master Cylinder Components and Components Location
Components
1. Reservoir cap2. Reservoir3. Grommet4. Cylinder pin5. Retainer6. Primary piston assembly7. Secondary piston assembly8. Master cylinder body
...