>
Hyundai Equus Manuals

Hyundai Equus: Front Door Module Repair procedures - Front Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Door Module Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Loosen the front door outside handle base mounting screw (A).

4.
Using a screwdriver or remover, remove the extension cover (A).

5.
Disconnect the outside rear view mirror connector (A).

6.
Loosen the front door latch (B) mounting screws.
7.
After loosening the mounting bolts, then remove the front door module (A).
Tightening torque :
(A) : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
(B) : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

8.
Disconnect the connectors (A) and front door module wiring harness (B) from the front door module.

9.
Install in the reverse order of removal.
   
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
    Front Door Module Components and Components Location
    Component Location 1. Front door module ...

    Front Door Outside Handle Components and Components Location
    Component Location 1. Front door outside handle ...

    See also:

    Blower Unit Components and Components Location
    Component Location Components 1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...

    Purge Control Solenoid Valve (PCSV) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the speci ...

    Tire specification and pressure label
    The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures re ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com