Hyundai Equus: Erasing HomeLink® buttons
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Mirrors / Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash-after 20 seconds.
2. Release both buttons. Do not hold for longer than 30 seconds.
The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.
FCC ID: NZLZTVHL3 IC: 4112A-ZTVHL3
Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these
steps:
1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has
been completed.
2. When th ...
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may c ...
See also:
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wi ...
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the service cover (A).
3.
Disconnect the fuel tank pressure sensor connector (A) and the ...
Fuel Pressure Control Valve Description and Operation
Description
Fuel Pressure Control Valve is installed on the high pressure
fuel pump and controls fuel flow flowing into the injectors in
accordance with the ECM signal calculated based on vario ...
Categories
Hyundai Equus Manuals
